說明書 SONY PSP-1007 K

[. . . ] Part or parts missing from this kit must be reported within 60 days of purchase. No part or parts will be sent under warranty without proof of purchase. To receive part or parts under warranty, the service center must receive a proof of purchase and/or the defective part or parts. Should you find a defective or missing part, contact the authorized Thunder Tiger Service/Distributor nearest you. [. . . ] Setting up the Failsafe (F/S) Function: a. After binding the transmitter and receiver, you can continually set up the F/S function. Turn on the transmitter power and then receiver power. Press and hold the “Binding SW” button on the receiver for 10 seconds. The LED will start flashing GREEN on the receiver. CAUTION: Do not release the “Binding SW” button on the receiver until STEP C is completed. Move and hold the throttle trigger to the position you want the control to be in if a failsafe condition should occur. First, keep steering wheel at neutral position steering servo at neutral position . To set up F/S function with the throttle servo position at "Brake", first push the trigger to the brake position and hold. To set up F/S function with servo position at "Neutral", keep the trigger at neutral position. NOTE: Always set the throttle trigger to neutral or full brake position and steering servo to neutral position in case of any unexpected control error!The carburetor opening should still be the same at neutral, throttle spring compressed slightly, and the brake engaged. a. 
 b. 
 8 c. 
 10 ADJUSTING THROTTLE / BRAKE LINKAGE a b c a. To set the throttle/brake linkage, first the radio should be on and neutral; thus, the servo is at neutral position. With the servo at neutral, turn and adjust plastic brake adjustment nut at the end of the linkage until there is a 1/16"(1. 5mm) gap between the spring and the brake lever when the spring is not compressed. ( The brake lever should almost engages the brake system, but not yet. ) c. With the servo at neutral, using a 1. 5mm Allen wrench driver to loosen the throttle collars. Then, manually close the carburetor, and set the forward collar (next to the spring) with the spring slightly compressed. Then, set the other collar (rearward) next to the linkage pivot. 1. 5mm 11 ADJUSTING CARBURETOR a d b d c e a. To set the high speed needle: (large needle sticking out from the carburetor body), turn the screw as pictured. Initial high speed needle setting should be 3~3. 5 turns (close the needle completely, then back out 3~3. 5 turns). [. . . ] EB4 S2 Description Engine will not start Problem Out of fuel Contaminated fuel Solution . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Fill fuel tank . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Charge glow igniter Glow plug igniter not charged Glow plug bad . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Replace glow plug, see "Glow Plug Problems" section below. [. . . ]