說明書 PHILIPS TT2021 TECHNICAL SPECIFICATIONS

[. . . ] Do not exchange or manipulate any part of it. Otherwise there is risk of electric shock. For usage in other body areas, please make sure that the skin is stretched. For hygienic reasons, do not share this appliance with other persons. Description 1 2 3 4 4a 4b 5 6 7 8 9 Foil protection cap Shaver foil Cutter block Rotating styler Wide shaper (28 mm) Narrow shaper (14 mm) Charging light On/off switch Trimming attachment Beard length selector Special cord set Charging The best environmental temperature for charging is between 15 °C and 35 °C. [. . . ] For hygienic reasons, do not share this appliance with other persons. Description 1 2 3 4 4a 4b 5 6 7 8 9 Foil protection cap Shaver foil Cutter block Rotating styler Wide shaper (28 mm) Narrow shaper (14 mm) Charging light On/off switch Trimming attachment Beard length selector Special cord set Charging The best environmental temperature for charging is between 15 °C and 35 °C. Do not expose the shaver to temperatures higher than 50°C for extended periods of time. • Using the special cord set, connect the shaver to an electrical outlet with the motor switched off. • When charging for the first time, leave the shaver to charge continuously for 4 hours. The green charging light (5) shows that the shaver is being charged. When the battery is fully charged, the charging light intermittently blinks on and off. This indicates that the battery maintains its full capacity. • A full charge provides 30 minutes of cordless shaving time depending on your beard growth. • Once the shaver is completely charged, discharge the shaver through normal use. Subsequent charges will take about 1 hour. Frequent use of the styler will reduce the battery capacity. Using the trimming attachment • The trimming attachment (7) is ideal for beard trimming and keeping it at a constant length. 12 • Place the trimming attachment onto the shaver foil (2) and press it against the shaver housing until it snaps into place with a click. • Press the beard length selector (8) (e) and slide it up in order to set the desired beard length (length settings from top to bottom 1. 2 mm, 2. 8 mm, 4. 4 mm, 6 mm). • Activate the on/off switch and trim against hair growth by guiding the transparent comb part over the skin. Cleaning Regular cleaning ensures better shaving performance. Rinsing the shaving head after each shave under running water is an easy and fast way to keep it clean: • Switch the shaver on (cordless) and rinse the shaving head under hot running water (f). A natural based soap may also be used provided it contains no particles or abrasive substances. Rinse off all foam and let the shaver run for a few more seconds. • Next, switch off the shaver, remove the shaver foil and the cutter block. Then leave the disassembled shaving parts to dry. [. . . ] Rinse off all foam and let the shaver run for a few more seconds. • Next, switch off the shaver, remove the shaver foil and the cutter block. Then leave the disassembled shaving parts to dry. • If you regularly clean the shaver under water, then once a week apply a drop of light machine oil onto the long hair trimmer and shaver foil (h). [. . . ]