說明書 PHILIPS HQ7390 TECHNICAL SPECIFICATIONS

[. . . ] (Modell HQ7390: 1 green charging segment only. ) The red low charge segment flashes when the battery capacity has dropped below 20%, provided the shaver is switched on. The remaining capacity will then be sufficient for 2 to 3 shaves. Description 1 2 3 4 5 6 7 8 9 10 11 12 Shaver foil Cutter block Foil release buttons Long hair trimmer Comfort setting switch «sensitive» On/off switch Shaver display Replacement light for shaving parts Reset button Shaver power socket Special cord set Etui Shaving Press the on/off switch (6) to operate the shaver. Comfort setting switch «sensitive» Setting the shaver head according to your comfort needs. [. . . ] Comfort setting switch «sensitive» Setting the shaver head according to your comfort needs. The «sensitive» switch (5) provides three options for comfort setting: Charging The best environmental temperature for charging is between 5 °C and 35 °C. Do not expose the shaver to temperatures higher than 50 °C for extended periods of time. • Using the special cord set (11), connect the shaver to an electrical outlet with the motor switched off and charge it for at least one hour. • A full charge provides up to 45 minutes of cordless shaving time. This may vary according to your beard growth. • If the rechargeable battery has run out of power (discharged), you may also shave by connecting the shaver to an electrical outlet via the special cord set. 8 1 «+»: The shaver head is in full swing, freely follows the contours of your skin to provide more comfort. 2 middle position: The shaver head is semi-fixed for more control. 3 «–»: The shaver head is fixed for full control and precise handling in hard to reach areas. • Next, switch off the shaver, press the foil release buttons (3) to remove the shaver foil (1) and cutter block (2). Then leave the disassembled shaving parts to dry. • If you regularly clean the shaver under water, then once a week apply a drop of light machine oil onto the long hair trimmer and shaver foil. The following quick cleaning is another alternative cleaning method: • Press the foil release buttons (3) to lift the shaver foil (do not remove the foil completely). 5–10 seconds so that the shaved stubbles can fall out. Remove the shaver foil and tap it out on a flat surface. Using the brush, clean the inner area of the shaver head. However, do not clean the shaver foil nor the cutter block with the brush as this will damage them. [. . . ] Remove the shaver foil and tap it out on a flat surface. Using the brush, clean the inner area of the shaver head. However, do not clean the shaver foil nor the cutter block with the brush as this will damage them. [. . . ]