說明書 EPSON EPL-5900

[. . . ] S. ) 8. 5 x 11 ़ӧ A4 (Metric Letter) 210 x 297 ϴᚄ ᇳ݂ 50 ஻ 50 ஻ ਟဴ 016-1948-00 016-1949-00 Phaser ிՓႪ ிՓႪৢ኿ᡆ ৢ኿ᡆ Џψ A/Letter (U. S. ) 8. 5 x 11 ़ӧ (108 ጁ኿ᡆ ) A/Letter (U. S. ) 8. 5 x 11 ़ӧ (108 ጁ኿ᡆ ) A4 (Metric Letter) 210 x 297 ϴᚄ (176 g/m2) A4 (Metric Letter) 210 x 297 ϴᚄ (176 g/m2) ᇳ݂ 100 ஻ / ؐ஻ 30 এ኿ᡆ (1. 0 x 2. 625 ़ӧ኿ᡆ ) 100 ஻ / ؐ஻ 6 এ኿ᡆ (3. 33 x 4. 0 ़ӧ኿ᡆ ) 100 ஻ / ؐ஻ 14 এ኿ᡆ (38. 1 x 99. 1 ϴᚄ኿ᡆ ) 100 ஻ / ؐ஻ 8 এ኿ᡆ (67. 7 x 99. 1 ϴᚄ኿ᡆ ) ਟဴ 016-1812-00 016-1813-00 016-1814-00 016-1815-00 Phaser® 6200 ிՓႪৢӟߒᐠ 6 Xerox ૉ؅ᇄߣӇ Phaser CD/DVD ኿ᡆ‫ڷ‬ඨॲ ‫ڷ‬ඨॲ ໶Ҭ A/Letter (U. S. ) 8. 5 x 11 ़ӧ (50 ጁ၆ॏા ) ᇳ݂ 10 ஻ / ؐ஻ 2 এ኿ᡆ 20 ஻ / ؐ஻Ι७ 1 ඨॲ A/Letter (U. S. ) 8. If it is not installed properly in strict accordance with Xerox's instructions, it may cause interference with radio and television reception or may not function properly due to interference from another device. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: I I I I I Reorient or relocate the receiver (device being interfered with). Increase the separation between the printer and the receiver. Connect the printer into an outlet on a circuit different from that which the receiver is connected. Route the interface cables on the printer away from the receiver Consult the dealer, Xerox service, or an experienced radio/television technician for help. Changes or modifications not expressly approved by Xerox can affect the emission and immunity compliance and could void the user's authority to operate this product. To ensure compliance, use shielded interface cables. A shielded parallel cable can be purchased directly from Xerox at www. xerox. com/officeprinting/6200supplies. Xerox has tested this product to internationally accepted electromagnetic emission and immunity standards. These standards are designed to mitigate interference caused or received by this product in a normal office environment. This product is also suitable for use in a residential environment based on the levels tested. In the United States this product complies with the requirements of an unintentional radiator in part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference; (2) this device must accept any interference received, including interference that may cause undesired operation. EXTINGUISHING MEDIA: Water, dry chemical, carbon dioxide, or foam. FIRE FIGHTING INSTRUCTIONS: Avoid inhalation of smoke. As for any fire, wear protective clothing and selfcontained breathing apparatus. SECTION 6 - ACCIDENTAL RELEASE MEASURES SPILL OR LEAK: Sweep up or vacuum spilled materials and carefully transfer into sealable waste container. Sweep slowly to minimize generation of dust during clean up. If a vacuum is used, the motor must be rated as dust tight. A conductive hose bonded to the machine should be used to reduce static buildup. Clean up residue if necessary with soap and cold water. Wash or dry clean garments after removing loose toner. SECTION 7 - HANDLING AND STORAGE HANDLING: No special precautions, when used as intended. STORAGE: Avoid high temperatures. Phaser® 6200 ிՓႪৢӟߒᐠ 19 ؅ਟԊӒೣਿਪ Ȟ༉़Мȟ SECTION 8 - EXPOSURE CONTROL - PERSONAL PROTECTION No special personal protection indicated, when used as intended in Xerox Phaser® color printers. THRESHOLD LIMIT VALUE (TLV): 10 mg/m3 (total dust) PERMISSIBLE EXPOSURE LIMIT (PEL): 15 mg/m3 (total dust); 5 mg/m3 (respirable dust) SHORT TERM EXPOSURE LIMIT (STEL): None established CEILING LIMIT: None established EPSON EXPOSURE LIMIT (XEL): 2. 5 mg/m3 (total dust); 0. 4 mg/m3 (respirable dust) SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES APPEARANCE/ODOR: Black, blue, red, or yellow powders/faint odor BOILING POINT: Not applicable SOLUBILITY IN WATER: Insoluble to negligible. EVAPORATION RATE: Not applicable VAPOR DENSITY (Air = 1): Not applicable VOLATILE (%): Not applicable SOFTENING RANGE: Not available MELTING POINT: Not available SPECIFIC GRAVITY (Water = 1): Not available VAPOR PRESSURE (mm Hg): Not applicable pH: Not applicable SECTION 10 - STABILITY AND REACTIVITY STABILITY: Stable. [. . . ] EVAPORATION RATE: Not applicable VAPOR DENSITY (Air = 1): Not applicable VOLATILE (%): Not applicable SOFTENING RANGE: Not available MELTING POINT: Not available SPECIFIC GRAVITY (Water = 1): Not available VAPOR PRESSURE (mm Hg): Not applicable pH: Not applicable SECTION 10 - STABILITY AND REACTIVITY STABILITY: Stable. INCOMPATIBILITY WITH OTHER MATERIALS: Strong oxidizers HAZARDOUS POLYMERIZATION: Will not occur HAZARDOUS DECOMPOSITION PRODUCTS: During a fire, toxic gases may be generated by thermal decomposition or combustion. SECTION 11 - TOXICOLOGICAL INFORMATION This material has been evaluated by Xerox Corporation. The toxicity data noted below is based on test results of the materials described herein or similar toners. Oral LD50: >5 g/kg (rats), practically non-toxic Dermal LD50: > 5 g/kg (rabbits), practically non-toxic Inhalation LC50: > 5 mg/l (rats; 4 hour exposure), practically non-toxic Eye Irritation: Not an irritant Skin sensitization: Not a sensitizer Skin irritation: Not an irritant Mutagenicity: No mutagenicity detected in Ames assay Carcinogens: None present Phaser® 6200 ிՓႪৢӟߒᐠ 20 ؅ਟԊӒೣਿਪ Ȟ༉़Мȟ Additional Information: The results obtained from a Xerox sponsored Chronic Toner Inhalation Study demonstrated no lung changes in rats for the lowest (1 mg/m3) exposure level (ie. , the level most relevant to potential human exposure). [. . . ]