說明書 ASUS P5SD2-X

[. . . ] Motherboard P5SD2-X T2026 © 2005 2 3 4 5 6 • • • • • • • • • • • • 7 • • • 8 1 2 Jumper Mode 2 3 Jumper Free (Default) P5SD2-X-TAYZ 6 10839 11036 0 11XXX11XXX11 9 ® ® ® 10 11 12 1-1 ® ® ® 1-2 ® ® ® ® ® 1-3 1-4 P5SD2-X SB_PWR ® P5SD2-X Onboard LED ON Standby Power OFF Powered Off 1-5 1-6 ® P5SD2-X 22. 4cm( 8. 8in) PS/2KBMS T: Mouse B: Keyboard EATX12V DDR2 DIMM_A1 (64 bit, 240-pin module) DDR2 DIMM_A2 (64 bit, 240-pin module) PARALLEL PORT SPDIF_O LGA775 COM1 USB12 USBPW12 USBPW34 LAN_USB34 P5SD2-X DDR2 DIMM_B1 (64 bit, 240-pin module) DDR2 DIMM_B2 (64 bit, 240-pin module) Top:Line In Center:Line Out Below:Mic In SiS 656 CPU_FAN CHA_FAN PCIEX1_1 Intel RC82540EM PCIEX16 PCI1 Super I/O ® CR2032 3V Lithium Cell CMOS Power PCI2 SATA1 PCI3 AD1986A FLOPPY PCIEX1_2 PRI_IDE USBPW78 USBPW56 GAME USB56 USB78 SATA2 FP_AUDIO CD AUX SB_PWR CHASSIS CLRTC PANEL 4Mb BIOS SiS 965L SEC_IDE 30 5cm (12 0in) EATXPWR 1-7 ® • ® ® • • • ® P5SD2-X CPU Socket 775 1-8 P5SD2-X A B 1-9 A B 1-10 ® ® • • ® ® ® • ® ® 1-11 B A A A B B B A P5SD2-X CPU_FAN GND CPU FAN PWR CPU FAN IN CPU FAN PWM ® P5SD2-X CPU fan connector 1-12 B A A B A B B A 1-13 1-14 P5SD2-X DIMM_A1 DIMM_A2 ® P5SD2-X 240-pin DDR2 DIMM sockets • • • • • DIMM_B1 DIMM_B2 1-15 1-16 2 3 1 • • 2 1 1 1-17 1-18 A B C D E F G H 1-19 1-20 P5SD2-X CLRTC ® 1 2 Normal (Default) 2 3 Clear CMOS P5SD2-X Clear RTC RAM 1-21 USBPW12 USBPW34 1 2 P5SD2-X 2 3 +5V (Default) +5VSB USBPW78 USBPW56 ® 1 2 2 3 P5SD2-X USB device wake-up +5V (Default) +5VSB 1-22 1 2 3 4 5 6 11 10 9 8 7 1-23 P5SD2-X FLOPPY PIN 1 R P5SD2-X Floppy disk drive connector 1-24 • • R P5SD2-X SEC_IDE PRI_IDE PIN 1 PIN 1 P5SD2-X IDE connectors 1-25 P5SD2-X SATA1 GND RSATA_TXP1 RSATA_TXN1 GND RSATA_RXN1 RSATA_RXP1 GND ® SATA2 P5SD2-X SATA connectors GND RSATA_RXP2 RSATA_RXN2 GND RSATA_TXN2 RSATA_TXP2 GND CPU_FAN GND CPU FAN PWR CPU FAN IN CPU FAN PWM P5SD2-X CHA_FAN ® GND +12V Rotation P5SD2-X Fan connectors 1-26 ® P5SD2-X P5SD2-X Front panel audio connector USB56 USB+5V USB_P5USB_P5+ GND P5SD2-X USB 2. 0 connectors ® P5SD2-X 1 USB+5V USB_P6USB_P6+ GND NC FP_AUDIO 1 USB+5V USB_P7USB_P7+ GND USB78 MIC2 MICPWR Line out_R NC Line out_L AGND +5VA BLINE_OUT_R BLINE_OUT_L USB+5V USB_P8USB_P8+ GND NC 1-27 • • • • ® ® • EATX12V GND GND GND GND +12V DC +12V DC +12V DC +12V DC EATXPWR +3 Volts -12 Volts Ground PSON# Ground Ground Ground -5 Volts +5 Volts +5 Volts +5 Volts Ground +3 Volts +3 Volts Ground +5 Volts Ground +5 Volts Ground Power OK +5V Standby +12 Volts +12 Volts +3 Volts ® P5SD2-X ATX power connectors 1-28 P5SD2-X ® P5SD2-X ® P5SD2-X Internal audio connectors P5SD2-X intrusion connector P5SD2-X CD(Black) +5VSB_MB Right Audio Channel Ground Ground Left Audio Channel CHASSIS (Default) Chassis Signal GND AUX(White) Right Audio Channel Ground Ground Left Audio Channel 1-29 PLED PLED+ P5SD2-X SPEAKER +5V Ground Ground Speaker PWR Ground PANEL IDE_LED+ IDE_LED® PLED- IDE_LED RESET PWRSW P5SD2-X System Panel connector * Requires an ATX power supply. • • • • • 1-30 Reset Ground 2-1 2-2 EZFlash starting BIOS update Checking for floppy. . . EZFlash starting BIOS update Checking for floppy. . . [. . . ] Start flashing. . . 2-6 Bad BIOS checksum. Checking for floppy. . . Bad BIOS checksum. Start flashing. . . 2-7 2-8 2-9 2-10 2-11 System Time System Date Legacy Diskette A Primary IDE Master Primary IDE Slave Third IDE Master Third IDE Slave Fourth IDE Master Fourth IDE Slave IDE Configuration Onboard PCI S-ATA Controller System Information [11:51:19] [Thu 10/13/2005] [1. 44M, 3. 5 in] : [ST320413A] : [Not Detected] : [Not Detected] : [Not Detected] : [Not Detected] : [Not Detected] [Native] Use [ENTER], [TAB] or [SHIFT-TAB] to select a field. Use [+] or [-] to configure system time. 2-12 System Time System Date Legacy Diskette A Language Primary IDE Master Primary IDE Slave Secondary IDE Master Secondary IDE Slave Third IDE Master Fourth IDE Master IDE Configuration System Information [11:10:19] [Thu 03/27/2003] [1. 44M, 3. 5 in] [English] :[ST320413A] :[ASUS CD-S340] :[Not Detected] :[Not Detected] :[Not Detected] :[Not Detected] Use [ENTER], [TAB] or [SHIFT-TAB] to select a field. Use [+] or [-] to configure system time. +Tab F1 F10 ESC Select Screen Select Item Change Field Select Field General Help Save and Exit Exit Advanced Chipset settings WARNING: Setting wrong values in the sections below may cause system to malfunction. Configure DRAM Timing by SPD Memory Acceleration Mode DRAM Idle Timer DRAm Refresh Rate Graphic Adapter Priority Graphics Aperture Size Spread Spectrum ICH Delayed Transaction MPS Revision [Enabled] [Auto] [Auto] [Auto] [AGP/PCI] [ 64 MB] [Enabled] [Enabled] [1. 4] +F1 F10 ESC Select Screen Select Item Change Option General Help Save and Exit Exit 2-13 System Time System Date Legacy Diskette A Primary IDE Master Primary IDE Slave Third IDE Master Third IDE Slave Fourth IDE Master Fourth IDE Slave IDE Configuration Onboard PCI S-ATA Controller System Information [11:51:19] [Thu 10/13/2005] [1. 44M, 3. 5 in] :[ST320413A] :[Not Detected] :[Not Detected] :[Not Detected] :[Not Detected] :[Not Detected] [Native] Use [ENTER], [TAB] or [SHIFT-TAB] to select a field. [. . . ] <Enter> again to disabled password. Change Supervisor Password 2-33 Security Settings Supervisor Password User Password : Not Installed : Not Installed [Full Access] [Setup] Change Supervisor Password User Access Level Change User Password Clear User Password Password Check 2-34 Exit Options Exit & Save Changes Exit & Discard Changes Discard Changes Load Setup Defaults 2-35 2-36 3-1 ® ® 3-2 ® 3-3 3-4 3-5 3-6 A-1 ® ® ® ® ® ® ® ® ® ® ® ® ® A-2 A-3 ® ® ® ® ® ® ® ® A-4 [. . . ]