說明書 ASUS AP1600R-E2(BI2) DISK ARRAY & DRIVER INSTALLATION GUIDE TRADITIONAL CHINESE VERSION 1.0

[. . . ] done A:\> A:\>afudos /oMYBIOS03. rom AMI Firmware Update Utility - Version 1. 10 Copyright (C) 2002 American Megatrends, Inc. 0x0008CC00 (9%) 2-4 A:\>afudos /oMYBIOS03. rom AMI Firmware Update Utility - Version 1. 10 Copyright (C) 2002 American Megatrends, Inc. [. . . ] 0x0008CC00 (9%) 2-4 A:\>afudos /oMYBIOS03. rom AMI Firmware Update Utility - Version 1. 10 Copyright (C) 2002 American Megatrends, Inc. done A:\> User recovery requested. Checking for floppy. . . • • 2-5 User recovery requested. Reading file “AP1600R-E2(BI2). rom”. Checking for floppy. . . 2-6 Bad BIOS checksum. Plug And Play O/S PCI Lantency Timer Allocate IRQ to PCI VGA Palette Snooping PCI IDE BusMaster OffBoard PCI/ISA IDE Card IRQ3 IRQ4 IRQ5 IRQ7 IRQ9 IRQ10 IRQ11 IRQ14 [No] [64] [Yes] [Disabled] [Enabled] [Auto] [PCI [PCI [PCI [PCI [PCI [PCI [PCI [PCI Device] Device] Device] Device] Device] Device] Device] Device] NO: Lets the BIOS configure all the devices in the system. YES: Lets the operating system configure Plug and Play (PnP) devices not required for boot if your system has a Plug and Play operating system. IRQ15 DMA DMA DMA DMA DMA DMA Channel Channel Channel Channel Channel Channel 0 1 3 5 6 7 [PCI Device] [PCI [PCI [PCI [PCI [PCI [PCI Device] Device] Device] Device] Device] Device] 2-22 ACPI Aware O/S Suspend Mode ACPI 2. 0 Support ACPI APIC Support BIOS-->AML ACPI table Headless mode APM Configuration Hardware Monitor [Yes] [S1 (POS) only] [No] [Enabled] [Enabled] [Disabled] Enable/Disable ACPI support for Operating System. DISABLE: If OS does not support ACPI. 2-23 Power Management/APM Power Button Mode Hard Disk Time Out (Minute) Resume on Ring Resume on PXE# Resume on Keyboard Resume on PS2 Mouse Resume on RTC Restore on AC Power Loss [Enabled] [On/Off] [Disabled] [Disabled] [Disabled] [Disabled] [Disabled] [Disabled] [Power Off] 2-24 2-25 Hardware Monitor CPU Temperature MB Temperature CPU Fan Speed Chassis Fan Speed VCORE Voltage 3. 3V Voltage 5V Voltage 12V Voltage [40. 5ºC/102. 5ºF] [33ªC/91ºF] [3260RPM] [N/A] [ 1. 504V] [ 3. 360V] [ 5. 160V] [11. 328V] CPU Temperature 2-26 Boot Settings Boot Device Priority Boot Settings Configuration Security Specifies the Boot Device Priority sequence. Boot Device Priority 1st Boot Device 2nd Boot Device 3rd Boot Device [1st FLOPPY DRIVE] [PM-ST320413A] [SM-ASUS CD-S360] Hard Disk Drives 1st Drive 2nd Drive [PM-ST320413A] [xxxxxx Drive] 2-27 Boot Settings Configuration Quick Boot Full Screen Logo AddOn ROM Display Mode Bootup Num-Lock PS/2 Mouse Support Wait for ‘F1’ If Error Hit ‘DEL’ Message Display Interrupt 19 Capture [Enabled] [Enabled] [Force BIOS] [On] [Auto] [Enabled] [Enabled] [Disabled] Allows BIOS to skip certain tests while booting. This will decrease the time needed to boot the system. 2-28 Security Settings Supervisor Password User Password : Not Installed : Not Installed <Enter> to change password. <Enter> again to disable password. Change Supervisor Password Change User Password Clear User Password Boot Sector Virus Protection [Disabled] 2-29 Security Settings Supervisor Password User Password : Installed : Not Installed [Full Access] [Setup] [Disabled] <Enter> to change password. [. . . ] This will decrease the time needed to boot the system. 2-28 Security Settings Supervisor Password User Password : Not Installed : Not Installed <Enter> to change password. <Enter> again to disable password. Change Supervisor Password Change User Password Clear User Password Boot Sector Virus Protection [Disabled] 2-29 Security Settings Supervisor Password User Password : Installed : Not Installed [Full Access] [Setup] [Disabled] <Enter> to change password. [. . . ]